The Xbox One is already a wonderful package itself. However, with games like Cod 5, Modern Warfare, and Modern Warfare 2, increasing numbers of people find reasons to get a new said gaming console, or its accessories. The type of modification is really a reply to create a rapid fire modded Xbox One controller. Here are the steps concerning how to modify your original controller with a rapid fire controller.

The first step. Unscrewing the controller

Before you begin taking your controller apart, require a critical look in the controller first and continue to remember which parts go where because you will eventually ought to put everything rear. Begin by unscrewing all of the visible screws behind. Following this, prior to deciding to tug on the case, get rid of the batteries to reveal the hidden screws. Remove these as well.

2. Preparing true

Together with the controller facing down, slowly and thoroughly separate the front 1 / 2 of the casing in the circuit board. An opening in case could eventually are needed. Remember this before putting things back.

3. Placing The Rapid Fire Button

While other types of modifying the controller tend not to involve installation of a fresh button, this kind of guide does. Furthermore this make it easier to adjust the rate of rapid fire, it minimizes tampering with aspects of the circuit board, thereby minimizing the risk of damaging your modded Xbox One console controller.

Remember, kits for that rapid fire controller are available easily. It does not take button out of this kit that is to be placed over the hole from the casing, so put it gently prior to the circuit board is returned. You may have to snip out a few flaps to make method for the wires from the kit. This can be accomplished with whether cutter or even a pair of scissors.

Step 4. Soldering

Assuming that custom controllers ps4 know how to effectively start using a soldering iron, attach the red wire to the leftmost pin of the 4-pin horizontal series, as the blue wire solders to the rightmost pin of the identical series. The black (or green in some cases) wire attaches towards the center of the three vertical series right from the switch.

Soldering is the most crucial step to making the modded Xbox One system controller. It is because mistakes made within this stage can permanently damage your controller.

Step 5. Putting everything back

Carefully paying attention to the wires, try to close the circuit board along with the casing. This may be a little tricky for the reason that new wires can get in the way of things. Have the option because of these wires to occupy the empty spaces as an alternative to protruding. You may contain the modded Xbox One console controller facedown so that the buttons don’t fall and maneuvering the wires are a little easier. Put the casings together but don’t return the screws yet.
You have to verify that the rapid fire buttons work. When they don’t, you may want to restart both your console as well as the now modded Xbox One controller. This should solve the issue. Whether or not this doesn’t then you may have to go from the steps again to make sure.

For more information about rapid fire controllers xbox one explore this resource.