The Xbox One is already an incredible package in itself. However, with games like Call of Duty 5, Modern Warfare, and Cod : mw2, increasing numbers of people find good reasons to customize the said gaming console, or its accessories. One such modification can be a response to create a rapid fire modded Xbox One console controller. Listed here are the steps regarding how to modify your original controller into a rapid fire controller.

1. Unscrewing the controller

Prior to starting taking your controller apart, take a critical look on the controller first and try to remember which parts go where because you will eventually have to put everything back again. Begin with unscrewing all of the visible screws behind. After that, prior to deciding to tug involved, remove the batteries to reveal the hidden screws. Remove these too.

Step # 2. Preparing the Case

With the controller facing down, slowly and thoroughly separate the leading 1 / 2 of the casing in the circuit board. A hole in case will ultimately are necessary. Don’t forget this before putting things back.

Step three. Placing The Rapid Fire Button

While other types of modifying the controller tend not to involve installing a brand new button, this particular guide does. Besides this provide help to adjust the pace of rapid fire, it minimizes tampering with other aspects of the circuit board, thereby minimizing potential risk of damaging your modded Xbox One system controller.

Remember, kits to the rapid fire controller can be obtained easily. Oahu is the button because of this kit that is to be placed through the hole in the casing, so put it gently prior to the circuit board is returned. You might want to snip out a couple of flaps to produce way for the wires from the kit. You can do this with whether cutter or possibly a set of scissors.

Step four. Soldering

Let’s assume that you know how to use a soldering iron, attach the red wire towards the leftmost pin of the 4-pin horizontal series, whilst the blue wire solders towards the rightmost pin of the series. The black (or green in some cases) wire attaches for the middle of the three vertical series to the right of the switch.

Soldering is regarded as the crucial the answer to making the modded Xbox controller. It is because mistakes made with this stage can permanently damage your controller.

Step 5. Putting everything back

Carefully considering the wires, make an effort to close the circuit board and also the casing. This is usually a little tricky because the new wires can get when it comes to things. Find a way of those wires to occupy the empty spaces as opposed to sticking out. You could possibly contain the modded Xbox One console controller facedown so the buttons don’t fall and maneuvering the wires can be a little easier. Place the casings together but don’t return the screws yet.
ps4 modded controllers need to see if the rapid fire buttons work. Whenever they don’t, you may need to restart both your console along with the now modded Xbox One system controller. This should solve the issue. If it doesn’t then you can have to go over the steps again to check.

For additional information about xbox one mod controllers site: look at here.